AUDIOQUEST Wind RCA kontakt 1Meter

Säljes av Jean-Michel.  

Inlagd: 2020-09-07 11:07.


AUDIOQUEST Wind  RCA kontakt  1Meter AUDIOQUEST Wind  RCA kontakt  1Meter AUDIOQUEST Wind  RCA kontakt  1Meter AUDIOQUEST Wind  RCA kontakt  1Meter AUDIOQUEST Wind  RCA kontakt  1Meter

11000:-

Kategori: Kablar    Göteborg: Visa på karta

AUDIOQUEST Wind RCA kontakt 1Meter till salu
En liten kosmetisk defekt men ingenting som påverkar ljudet
Kan köpas helt ny för 22000:- sek hos Hifi Klubben
Kan tänka bytas mot nåt roligt ....Skojare undanbedes

BESKRIVNING
SOLID PERFECT-SURFACE SILVER (PSS) CONDUCTORS
Perfect-Surface Technology applied to extreme-purity silver provides unprecedented
clarity and dynamic contrast. Perfect-Surface Silver (PSS) is AudioQuest's highest-
quality metal. Solid conductors prevent strand interaction, a major source of cable
distortion. Extremely high-purity Perfect-Surface Silver minimizes distortion caused
by the grain boundaries that exist within any metal conductor, nearly eliminating
harshness and greatly increasing clarity compared to OFHC, OCC, 8N and other
coppers.
FEP AIR-TUBE INSULATION (FEP IS A FLUORO-POLYMER)
Any solid material adjacent to a conductor is actually part of an imperfect circuit. Wire
insulation and circuit board materials all absorb energy (loss). Some of this energy is
stored and then later released as distortion. Air, however, absorbs next to no energy,
and FEP is the best extrudable solid insulation, absorbing less energy than other
materials. The use of FEP Air-Tube insulation, with almost nothing but air around the
solid PSC+ conductors, improves the sound of an audio system's focus and dynamics.
TRIPLE-BALANCED GEOMETRY (SEPARATE GROUND-REFERENCE CONDUCTOR)
Our Triple-Balanced Geometry uses a separate ground-reference conductor, so the
cable's shield is never used as an inferior conductor. Whether prepared with RCA or
XLR plugs, the cable's three conductors ensure that the positive and negative signals
have equally superior, low-distortion conducting paths.
CARBON-BASED 6-LAYER NOISE-DISSIPATION SYSTEM (NDS)
It's easy to accomplish 100% shield coverage. Preventing captured Radio Frequency
Interference (RFI) from modulating the equipment's ground reference requires AQ's
Noise-Dissipation System (NDS). Traditional shield systems typically absorb and then
drain noise/RF energy to component ground, modulating and distorting the critical
"reference" ground plane, which in turn causes a distortion of the signal. NDS's
alternating layers of metal and carbon-loaded synthetics "shield the shield,"
absorbing and reflecting most of this noise/RF energy before it reaches the layer
attached to ground.
DIELECTRIC-BIAS SYSTEM WITH RADIO FREQUENCY TRAP
All insulation between two or more conductors is also a dielectric whose properties
will affect the integrity of the signal. When the dielectric is unbiased, dielectric-
involvement (absorption and non-linear release of energy) causes different amounts
of time delay (phase shift) for different frequencies and energy levels, which is a real
problem for very time-sensitive multi-octave audio. The inclusion of an RF Trap
(developed for AudioQuest’s Niagara Series of power products), ensures that radio
frequency noise will not be induced into the signal conductors from the DBS field
elements. (DBS, US Pat #s 7,126,055 & 7,872,195 B1)
COLD-WELDED, HANGING-SILVER PLATING DIRECTLY OVER HIGH-PURITY RED
COPPER PLUGS

https://www.hifiklubben.se/audioquest-wind-rca-signalkabel/aqwindin1,0/

Mejla Mejla Jean-Michel.

Ändra/to bort annons Ta bort eller ändra annonsen

Anmäl annonsen Anmäl annonsen

Fler annonser från Jean-Michel

Audioquest NRG serie nät kablar köpes
Kul Slutsteg från  80 -90 talet sökes
Furutech nät kablar The Odeon  eller G320 Ag -18e